Milling machines can be pretty intimidating beasts to work with, what with the power to cut metal and all. Mount a fly cutter in the mill and it seems like the risk factor goes up exponentially.

Vibration, excessive heat and silicon dust can bring a $300,000+ milling machine to a grinding ... Visually inspect the cutter teeth and spot-change any that need to be replaced.

Did you know that the show was postponed for WWII? Or that McCormick Place was expanded in the ’70s just to accommodate IMTS? A fascinating look at the show’s history from 1927 to today.

The doctor can order a biopsy – which means cutting out a piece of the skin for further ... The results: a few light brown seborrheic keratosis (benign skin growths that look like small spots) on my ...

Invest in quality with long-lasting products. Learn about the durability of leather boots, stainless steel knives, and cast ...

accuracy of cutting ... flat front of the semi-circle with a mill. machined off (with a mill) the top and bottom of the semi circle (look at the pic above). then put that whole long semicircle with ...

You may even spot some unexpected finds here ... ago in a Neoclassical former bank building plus a complex of warehouses that ...

Detroit Lakes NARFE: Detroit Lakes Chapter 1842 of the National Active and Retired Federal Employees (NARFE) association will ...

The start of the NHL's 2024-25 regular season is fast approaching, leaving the Toronto Maple Leafs facing some cost-cutting ...

Instead of going to college, Pavlik went to work at a steel mill, rolling and cutting large metal tubes ... At 5:15, I drove ...

Art in the Loft, on the third floor of the Center Building at 109 N. 2nd Ave. in Alpena, is open from 10 a.m. to 5 p.m.

Here is a look at a selection of spots where you can get you spook on ... From a cider fest at the state's first modern cider mill to a grape-stomping festival to a cider release devoted to ancient ...